ZHEJIANG HUAYANG ELECTRIC CO., LTD.
Electronic Voltage Relay RST 25

Electronic Voltage Relay RST 25

Send Inquiry

Electronic Voltage Relay RST 25 renders control not only over under-voltage and over-voltage, but offers phase flashing and sequence. It also helps in adjusting the switch off time by possessing the time delay feature. The mentioned relay recognizes the failure, if occurred and then switches of the time delay setting for protecting the circuit.

Operation Instructions

The electronic phase relay RST 25 offers phase, philure shift, phase flashing, asymmetric, Phase sequence and also under and overvoltage control.

Connection

The RST 25 can be connected as following in the installation diagram: FIG1: connection of the relay before operation. When the relay is connected as in FIG 1, the there yellow LED’ sL1, L2 and L3 light up when The power supply A1 phase L, the A2 Neutral, and the three phases “L1”, “L2”and “L3”are connected. If there is no under or overvoltage, phase failure or phase sequence, the green LED lights up, (terminals 11 and 14 are closed )and the relay is ready for self retaining. It is also possible to connect the power supply after operation in FIG2. By both FIG’ s 1 and 2, the terminal “PE” must be grounded.

Undervoltage

The desired undervoltage limit can be adjusted down to-25UN. Asymmetry The adjusting over-and undervoltage limit, the asymmetric limit is slso adjusted.

Time Delay

The switch off time can be adjusted by the potentiometer “Time Delay” from 0.1……5 seconds. With this function it is possible to adjust the time for the identification of the failure.

Contactor Control

If a phase fails during operation at load or one of the contacts of the contactor or circuit Breaker is defective,(contact bounce or scorched contacts), RST 25 recognizes the failure, And also the feedback voltage, and switches off depending on the setting of “Time Delay”. The RST 25 controls the phase shift. If there is a phase failure the angle from the feedback Voltage is 30°. The RST 25 recognizes this failure.

Technical Specifications:

Power Consumption

2VA

Ambient Temperature

25° …65°

Phase Angle

120°±8°@UN=UU

Under voltage

Adjustable to -25UN

Overvoltage

Adjustable to +25UN

Tripping time

0.1…5 seconds

Life of the Instrument

20χ106 mechanical switchings

Air-gap and Leakage path

Group C, 250V, VDE 0110

Relay Output

1 C/0 contact, 16A, 250V VDE, SEV, SEMKO, AgCdO

High-voltage test

2500V

Shock voltage test

5KV VDE0435

Housing Type

1P 40, DIN 40 050

Weight

325g

Dimension

H=75mm, W=45mm, D=120mm